The flashing extends onto the roof a minimum of 2 inches 4 inches is preferable in more severe climate areas.
Sidewall roof flashing.
For counter flashing i cut and bent mine from a roll of 10 valley flashing.
Butyl tape should be applied where the foot of the flashing attaches to the roof.
Our page top photograph illustrates a successful installation of flashing and counter flashing along intersection of a roof surface with the side of a brick constructed dormer.
Flashing joints are lapped 6 in the direction of water flow.
The flashing extends up the wall at least 4.
Universal sidewall trim is designed to flash from your metal roof panels to a vertical wall such as a chimney.
The universal sidewall trim combined with sealant provides a watertight seal for your roof system.
For me the self seal flashing keep my step flashing where i wanted it.
Universal sidewall trim is designed to flash from your metal roof panels to a vertical wall such as a chimney.
The wall side of the flashing can either be covered over with siding or sealed with caulk.
Peel and stick flashing.
Sidewall flashing is applied when the side of the roof butts up against an adjacent wall.
Not really a good idea but the previous set up did this i did not.
Nailing the step flashing into the roof shingles.
Striations and bends on the flashing provide strength and match the lines of your other edge trims.
