Once the cut is finished use the unload button on your machine to unload your vinyl.
Silhouette blade cutting through vinyl backing.
I sure hope it works.
Place the vinyl onto the silhouette cutting mat with the backing paper side down onto the mat making sure the vinyl is covering the same area where the design is placed on the virtual mat in silhouette studio.
The end cap unscrews while it s cutting it won t automatically set itself to the cut settings in the send menu etc.
This is a tool you can use to change the setting on the blade.
If your silhouette cutting mat is brand new you may want to de stick the cutting mat somewhat by blotting it with a clean t shirt.
If you ve just replaced your blade and are having this problem you probably have the wrong blade.
My friend and fellow instructor elly from silhouette secrets has diagnosed this issue so often on facebook that she keeps a photo of a properly installed blade on hand to post whenever someone is having cutting issues.
Blade ratchet to change blade setting on each machine made in the last 3 years or so there is a round indentation on the machine in the lower left hand side.
If your cricut cuts through the backing there are usually one of two possible issues.
The same goes for the portrait 2 autoblade.
Once the vinyl is removed look at your test cut.
Trying out new vinyl or felt a blunt blade or any other number of reasons.
1 blade is not properly inserted and or locked down.
Just remove the blade from the carriage put it blade side down into the indention and turn until the blade is on the setting you want.
This video shows how i resolved a silhouette vinyl cutting issue.
Can the triangle be removed completely without any places sticking.
How to stop cutting through vinyl backing.
When cutting adhesive vinyl or heat transfer vinyl a kiss cut is used to cut the vinyl but leave the carrier sheet or backing intact.
For me this is the bane of using vinyl.
Silhouette finally has more autoblades available and is sending me a new one.
If this happened the blade is cutting too deep.
Did the machine cut all the way through to the back.
I can use an older style ratchet blade in the adapter and it will cut fine.
Did it cut cleanly through the vinyl.
It took me a long time to get it right and i often have to make small adjustments for various reasons ie.
