Gasket to push outward.
Sink stopper won t seal.
How to fix a sink pop up drain stopper.
If water still does not hold in the sink the next check will be the actual stopper seal.
Water may leak or refuse to drain around a sink pop up for a number of reasons.
If your sink pop up won t pop up or seat properly fixing it is quite easy usually just a matter of adjusting a few parts.
Now that the bottom of the tailpipe if free from the p trap loosen the nut that connects it to the threaded bottom of the sink drain.
Re tighten the thumb screw by turning clockwise.
A pivot rod that connects to the back of the drain pipe a perforated strap a clevis and a screw that locks the strap onto the stopper rod.
Remove clip from ball rod.
5 shows the gasket pushed out of position.
6 shows the gasket seated correctly between the clicker assembly and the stopper.
The gasket located under the stopper may also need to be adjusted.
A sink stopper with a push pull rod control at the faucet is a great modern convenience.
To reach the stopper the ball rod needs to be removed first.
The photo on the left fig.
A sink stopper mechanism isn t difficult to understand.
It s easy to fix a bathroom sink drain plug that s leaking.
Remove stopper from drain.
When you push or pull on the lift rod it activates a lever the extends through the drain tailpiece.
But sink stoppers fail.
The ball rod holds the stopper in the drain.
Find replacement parts on amazon.
The culprit is often a buildup of hair around the base of the stopper or the pivot rod mechanism.
Most sink stopper tailpipes are made of pvc and will be connected to the drain with a pvc compression nut that you can loosen by hand.
The photo on the right fig.
This is a repair you can do yourself.
It moves the stopper in the opposite direction to the lift rod.
Fix a sink stopper.
Unthread the sink stopper s tailpipe from the underside of the drain.
When they do they are often unsightly and an irritation.
If a sink won t hold water look up behind the sink with a flashlight if needed to identify the following parts.
Peek above the sink to make sure the stopper is fully closed and that the pop up rod is pushed all the way down 3.
The lever hooks onto the stopper through a hole or hook on the bottom of a long plastic flange that s attached to the stopper.
The clicker may have been over tightened causing the.
The ball rod is inserted into the side of the drain and attached with a nut.
